Datamax-oneil DPL Programmer’s Manual Manual do Utilizador descarregar pdf (Página 106)

Extended System-Level Command Functions

STX KI GPIO Input

Future - This command configures the GPIO input channels of the Applicator Interface

Card; see Appendix J for details.

Syntax:

STX>KIffnspwww

Where:

- 2 character function name abbreviation (e.g., PS [Print

Start], I1 [User Input 1], etc).

- Pin number, where 1 – 8 is the valid range.

- Signal type, where: L = Level; P = Positive Pulse;

and N = Negative Pulse

- Polarity, where: 0 = Active Low; and 1 = Active High

www

- 3 character filter pulse width, in milliseconds.

STX Kn NIC Reset

This command resets the NIC to factory defaults.

Syntax:

STX>Knx

Where:

- Specifies the action, where:

F = Returns the NIC to the factory default settings; or,

RH = Reports settings.

RP = Prints reports

Address

Default Values

Wired Ethernet*

Default Values

Wireless Ethernet

192.168.010.026 192.168.010.001

Subnet Mask

255.255.255.000 255.255.255.000

Gateway

000.000.000.000 000.000.000.000

* Prior to introduction of the Wireless Ethernet, 192.0.0.192

was the IP default value and the Subnet Mask was 0.0.0.0.

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 295 296

Sem comentários

Datamax-oneil DPL Programmer’s Manual Manual do Utilizador Página 106