Datamax-oneil M-Class Mark II Operator’s Manual Manual do Utilizador descarregar pdf (Página 72)

Chapter 6 – Troubleshooting 66

Printer Fault Messages (continued)

Displayed Message Description Possible Solution(s)







The printer could not find

the TOF mark within the

maximum label length

setting or it found a TOF in

an unexpected place.



When the printer is set

for reflective media, this

fault is given for an out of

stock condition.

If media is moving:

1) Press the FEED Key. It may be

necessary to re-calibrate the printer;

see Section 3.5.

2) The Media Sensor may be out of

position. Readjust it; see Section 2.3.

3) The media may not be properly loaded.

Reload media, also ensure that the

Media Guide is positioned properly; see

Section 2.2.

4) The Media Width Adjustment may be

improperly adjusted; see Section 5.3.

5) The label may be longer than the default

value for maximum length. Check the

Media Settings / Maximum Label Length;

see Section 4.5.

6) The Media Sensor may be obstructed.

Check and carefully remove any

obstruction (labels, paper dust,

adhesive, etc).

If media is not moving:

The printhead assembly may not be latched.

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 99 100

Sem comentários

Datamax-oneil M-Class Mark II Operator’s Manual Manual do Utilizador Página 72