Datamax-oneil M-Class Mark II Operator’s Manual Manual do Utilizador descarregar pdf (Página 70)

100

Chapter 6 – Troubleshooting 64

Printer Fault Messages (continued)

Displayed Message Description Possible Solution(s)









Consistently high sensor

readings were detected.

Press any key to continue. Ensure that

media was removed from the media sensor

during the appropriate calibration steps;

also ensure that no labels are stuck in the

media sensor. Retry the calibration. If the

problem persists, call for service.







The printer can not detect

media.

Try the following:

1) Load media.

2) Ensure that the labels are passing

through the Media Sensor.

3) Readjust the Media Sensor over the TOF

mark; see Section 2.3.

4) If using media with large gaps, adjust

the Paper Empty Distance.

5) Calibrate the printer; see Section 3.5.





Two possible causes:

(1) The printer was

powered-off or reset during

a ribbon, out of stock or

TOF fault; or (2) the printer

was unable to complete the

Media Calibration.

Depending upon the cause:

(1) Press the FEED Key in an attempt to

identify and then clear the related fault

condition; or (2) if necessary, calibrate the

printer; see Section 3.5.





The printer has detected a

problem within the print

logic.

Try cycling the printer power ‘Off’ and ‘On’.

If the fault does not clear, call for service.





The system has detected a

RAM failure.

Try cycling the printer power ‘Off’ and ‘On’.

If the fault does not clear, call for service.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 99 100

Comentários a estes Manuais

Sem comentários

Datamax-oneil M-Class Mark II Operator’s Manual Manual do Utilizador Página 70

Comentários a estes Manuais

Manuais e produtos relacionados com Impressoras Datamax-oneil M-Class Mark II Operator’s Manual