Datamax-oneil S-Class DTPL Programmer’s Manual Manual do Utilizador

DTPL Programmer’s Manual

DTPL Programmer’s Manual 4 Font Size Command <Fx> This command sets the font size. The defaults is F3. x= 1 for Font1 characters (5x7) 2 for

DTPL Programmer’s Manual 5 DTPL Status Commands 3.0 Introduction The status-enabled function must be set to activate these commands. Command Fo

DTPL Programmer’s Manual 6 Command Format Description No Status <S5> or <s5> Disables the transmission of all status information, exc

DTPL Programmer’s Manual 7 DTPL File Commands 4.0 Introduction The printer supports three modes of file storage: Resident: Files are stored

DTPL Programmer’s Manual 8

DTPL Programmer’s Manual 9 DTPL Print Commands 5.0 Introduction The following table lists the printer’s various print commands. Command Format

DTPL Programmer’s Manual 10

DTPL Programmer’s Manual 11 DTPL Special Commands 6.0 Introduction The following commands are to be transmitted independently (without the <

DTPL Programmer’s Manual 12

DTPL Programmer’s Manual 13 DTPL Downloading Commands 7.0 Downloading Commands Logos can originate in one of two manners. They can be permanentl

DTPL Programmer’s Manual 14 The above routine should be repeated for each line of logo data. For the remaining lines, a CR should be used in place of

DTPL Programmer’s Manual 15 DTPL TEXT LOGO (MACRO) SUPPLEMENT The printer can store a string of DTPL commands (a macro) in memory as if they were a

DTPL Programmer’s Manual 16

DTPL Programmer’s Manual 17 Barcodes 8.0 Barcodes UPC UPC (version A) is a numeric only code which contains a left hand border character, 6 le

DTPL Programmer’s Manual 18 A typical ladder orientation bar code with interpretation and a default width of 4 would be sent as follows. "<R

DTPL Programmer’s Manual 19 USS-CODABAR USS-CODABAR is a numeric bar code with 6 special characters (-$:/.+) and 4 start/stop characters (A,B,C,D).

DTPL Programmer’s Manual 20

DTPL Programmer’s Manual A-1 Appendix A ASCII Control Chart Char Dec Hex Char Dec Hex Char Dec Hex Char Dec Hex Ctrl @ NUL 0

DTPL Programmer’s Manual A-2 ASCII Control Chart (concluded) Char Dec Hex Char Dec Hex Char Dec Hex Char Dec Hex Ç 128 80 á 160 A0

Information in this manual is subject to change without notice and does not represent a commitment on the part of Datamax-O’Neil Corporation.

i Contents Introduction 1.0 Manual Overview...

ii

DTPL Programmer’s Manual 1 Introduction 1.0 Manual Overview This manual is designed for users who wish to create their own label production soft

DTPL Programmer’s Manual 2 1.3 Bar Codes The following highlights some key points on printing barcodes:  All available barcodes (Code 39, Interle

DTPL Programmer’s Manual 3 DTPL Command Sequences 2.0 Introduction The printer can accept a wide variety of commands to control the printing of d