Datamax-oneil M-Class Mark II RFID Option Manual do Utilizador descarregar pdf (Página 6)

Encoded RFID data can also be exported to a host device by enabling OPTION FEEDBACK. This data is

contained in the format <A;B;C;D;E;F>[CR] where:

A - Is the device type: R = RFID; and, S = Linear Scanner.

B - Is the resulting status: C = label complete; F = faulted (failed) label; and, U = unknown.

C - Is the number of expected reads for bar codes or tags, given in two characters.

D - Is the number of good reads for bar codes or tags, given in two characters.

E - Is the printer’s internal Job and Sub Job Identifier, given in four characters each.

F - Is the data that was read, delimited with semicolons (;) on multiple reads.

Proceed as follows to capture RFID data:

Step Instruction Display

Press MENU.





Scroll to COMMUNICATIONS and press ENTER.





Scroll to HOST SETTINGS and press ENTER.





Scroll to OPTION FEEDBACK and press ENTER.





Select the output format (RFID HEX or RFID ASCII) and press ENTER.





Press ESC; and, at the SAVE CHANGES prompt, press ENTER to

complete the setup.







Notes: (1) For menu system details, see the Operator’s Manual.

(2) Bidirectional communications must also be enabled, and an appropriate cable attached.

1 2 3 4 5 6 7 8

Sem comentários

Datamax-oneil M-Class Mark II RFID Option Manual do Utilizador Página 6