Datamax-oneil I-Class Mark II GPIO Option Manual do Utilizador

GPIO Option92-2586-01 Rev.B

8 Setup and Operation The GPIO card has the following menu configurable features and can be tailored to your application. GPIO PORT Controls the

9 Test an Diagnostics  Input Monitor – Display incoming GPIO binary signal states using the DIAGNOSTICS  OPTIONS TESTING  TEST GPIO  MONITOR G

1 Overview This document describes the installation and use of the General Purpose Input Output (GPIO) option for the I-Class Mark II printer. Fo

2 Installing the Option If the GPIO Card is already installed in the printer, skip this section and proceed to “Configuring the Hardware”. Otherwi

3 C) Remove the 5mm Screw and Cover Plate from the rear of the printer. D) Remove the two Jack Screws from the GPIO Card, (these

4 F) Install the GPIO Card into the printer. First insert the “Port” end into the cut-out in the rear of the printer. Then pivot the GPIO Card onto

5 Configuring the Hardware Configure the card to meet your interfacing requirements by arranging hardware jumpers, as described in the following

6 For direct inputs – Default Configuration JMP2 and JMP3 installed. Uses the printer’s +5VDC and Ground to supply the devices interfacing to the

7 WARNING Failure to properly configure the GPIO Port can result in damage to the printer and / or connected devices. GPI/O Port A Jumper Overvi