Datamax O'Neil Mark III E-4305A Manual do Operador descarregar pdf (Página 37)

Chapter 4 – Maintenance and Adjustments 31

The optional Adjustable Media Sensor (AMS) allows the printer to accept a wider variety of media

configurations. The table below defines general AMS positions for various media and Top of Form (TOF) types.

AMS Positioning

Media Type

Sensor Location TOF Sensing Method

Continuous

Center of the Media Continuous

Die-Cut

Center of the Label

Notched

Center of the Notch

Gap

Reflective

Center of the Mark Reflective

Position the AMS as follows:

1) On the Bottom AMS Sensor, identify the proper Indicator for

use with your media.



Gap or Notch Indicator



Reflective (Mark) Indicator

2) Slide the Bottom AMS sensor so the Indicator is in line with the center of the notch, gap, or

reflective (mark) of the installed media.

3) Slide the Top AMS Sensor over to the same

setting as the Bottom AMS Sensor, (this is not

necessary if using reflective media).

312



Bottom AMS Sensor



Top AMS Sensor

4) Load media, see Section 2.3.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 57 58

Sem comentários

Datamax O'Neil Mark III E-4305A Manual do Operador Página 37