Datamax-oneil DMXrfNetIII Manual do Utilizador

Operation & Installation 92-2573-01 Rev.B

Printer’s Internal Web Pages 8 GENERIC NETWORK CONFIGURATION Page NETWORK INTERFACE NETWORK INTERFACE Selects WIRED ETHERNET (802.3) or WIRELESS

Printer’s Internal Web Pages 9 WIRED ETHERNET CONFIGURATION Page DHCP ENABLED/DISABLED Controls IP Address discovery, where: ENABLED: Broadca

Printer’s Internal Web Pages 10 DMXrfNet3 Page (continued…) ADHOC CHANNEL ADHOC CHANNEL When Wireless Network Type is Ad Hoc, selects the channel

Installing the Printer Driver 11 Installing the Printer Driver The following screen shots are taken from Windows 2000, other Windows versions wi

Installing the Printer Driver 12 9 Insert the Accessories CD-Rom and click ‘Browse’. 10 Browse to the “\DRIVERS\Seagull” folder on the CD-ROM, m

Additional Information 13 Wireless and Wired Ethernet Specifications The following list and table describes the key features and specifications of

Overview 1 Overview This document describes the installation and use of the DMXrfNetIII Card options for the H-Class and A-Class Mark II printers

Overview 2 Card Installation The following illustrations depict installation into an H-Class printer, other model installations are similar. On so

Overview 3 Introduction These network cards can be equipped in the following configurations:  Wired and Wireless Ethernet  Wireless Ethernet

Network Setup 4 Network Card Reset It is recommended that the printer’s communication settings be reset to factory defaults to avoid any conflicts

Network Setup 5 Network Card Setup - Wireless (Infrastructure Mode) After a successful setup is made via a wired connection, the Wireless conn

Network Setup 6 Network Card Setup - Wireless (Adhoc Mode) To configure the wireless card in Adhoc mode, you must configure your host computer

Printer’s Internal Web Pages 7 Printer’s Internal Web Pages 1. Open your web browser. Type in the IP Address of the printer. The Default IP is: